Keep it Simple at Fab'n' Funky Challenges

 Good morning, hope you're all keeping well and having a good week. It's time for this week's challenge at Fab'n'Funky- it's my turn to pick a theme  and I chose 'keep it simple'- it doesn't have to be a CAS card, anything with a simple design that was quick to make will be perfect.

I did make a card- it was quick and easy and it's just one layer, stamped directly onto the card blank- usually these are NOT quick or easy for me- something always goes wrong- but this time it worked. I inked up my large splat stamp with Distress Oxides, spritzed with water then laid the card blank on top and pressed down, a bit like using a Gelli plate. This meant that the inks didn't run off the stamp and drip everywhere (which is what has happened previously- maybe I'm a bit too generous with the spritzing :). I dried it with my heat gun then stamped the image and sentiment (Visible Image) on top using Versafine Clair ink. Finished. It took about 5 minutes start to finish. 

I was inspired by beautiful photos of my 2 eldest granddaughters taken on a beach, at sunrise, during the early part of the Lockdown. 

Thanks for visiting today

Chris

x

Challenge entries:

pathofpositivity #84

crafterscastle.#34

creativeknockouts #371

craftycreations #414

aperfecttimetocraft #10

do-allkreatives #46

LTCCB #51